CreatBot Materials
CreatBot Filaments
PEEK, PEKK, carbon fiber, nylon, and engineering-grade filaments optimized for CreatBot D-series high-temperature chambers.
CreatBot D-series printers are built for high-performance polymers that standard FDM machines can't handle. These filaments are validated for CreatBot's high-temperature extruders and enclosed chambers — delivering aerospace, medical, and industrial-grade mechanical properties.
All Filaments
6 materials available
PEEK Filament
Polyether ether ketone — the gold standard for high-performance FDM. Exceptional chemical resistance, continuous service temperature up to 250°C, and outstanding mechanical strength.
- Print Temp: 380–420°C
- Bed Temp: 120–160°C
- Tensile Strength: 100 MPa
- Service Temp: 250°C continuous
PEKK Filament
Polyether ketone ketone with higher crystallinity than PEEK. Excellent for structural aerospace components, chemical processing equipment, and medical implant prototypes.
- Print Temp: 340–370°C
- Bed Temp: 120–150°C
- Tensile Strength: 95 MPa
- Flexural Modulus: 4.5 GPa
Carbon Fiber Nylon
Short-carbon-fiber reinforced nylon for maximum stiffness-to-weight ratio. Ideal for jigs, fixtures, brackets, and structural prototypes requiring low weight and high rigidity.
- Print Temp: 260–280°C
- Bed Temp: 80–100°C
- Tensile Strength: 85 MPa
- Flexural Modulus: 8.5 GPa
Nylon PA12 Filament
Engineering-grade Nylon 12 for tough, flexible, and chemically resistant parts. Low moisture absorption compared to PA6, making it more dimensionally stable in humid environments.
- Print Temp: 240–260°C
- Bed Temp: 80–100°C
- Tensile Strength: 52 MPa
- Elongation at Break: 30%
PC (Polycarbonate) Filament
High-impact, optically clear polycarbonate for transparent enclosures, light pipes, and structural parts requiring impact resistance and moderate heat tolerance.
- Print Temp: 270–300°C
- Bed Temp: 100–120°C
- Tensile Strength: 68 MPa
- HDT: 138°C
TPU 95A Filament
Shore 95A thermoplastic polyurethane for flexible, abrasion-resistant parts. Excellent for seals, gaskets, cable management, and wearable components.
- Print Temp: 220–240°C
- Bed Temp: 40–60°C
- Shore Hardness: 95A
- Elongation at Break: 580%
Printing with high-performance polymers?
Our engineers can help you dial in print parameters for PEEK, PEKK, and reinforced materials on your CreatBot system.