Workshop Supplies

Tools & Finishing

Spatulas, mixing tools, safety equipment, IPA finishing supplies, and storage solutions to complete your 3D printing workflow.

The right tools make post-processing faster, safer, and more consistent. From part removal and support cleanup to surface finishing and safe chemical handling, this category covers everything you need beyond the printer itself.

All Tools & Supplies

Part Removal & Support Tools

Flush Cutters

Precision flush-cut pliers for clean support removal on SLA and FDM parts. Spring-loaded for reduced hand fatigue during long cleanup sessions.

Single pair

Part Removal Spatula Set

Stainless steel spatulas in three widths for safely prying SLA parts off the build platform without damage to the part or surface.

3-piece set

Needle-Nose Pliers

Fine-tip pliers for reaching into tight geometries to remove internal supports and clean up internal channels.

Single pair

Safety Equipment

Nitrile Gloves (Box of 100)

Chemical-resistant nitrile gloves rated for IPA and uncured resin handling. Available in S, M, L, XL.

Box of 100

UV Safety Glasses

Polycarbonate safety glasses with UV 405 nm blocking lenses. Required when working near Form Cure L or other UV curing sources.

Single pair

Resin Disposal Bags

UV-opaque disposal bags for curing and disposing of waste resin safely. Cure in sunlight before disposal per local regulations.

Pack of 50

Surface Finishing

Sandpaper Assortment

Wet/dry sandpaper in 220, 400, 800, 1200, and 2000 grit for progressive surface finishing of SLA and FDM parts.

25-sheet assortment

Primer Spray (Grey)

Filler primer for 3D printed parts. Fills layer lines and micro-porosity before painting. Compatible with SLA resin and FDM nylon surfaces.

400 mL aerosol

XTC-3D Surface Coating

Two-part epoxy coating that self-levels over FDM layer lines. Produces a smooth, glossy finish without sanding. Paintable after cure.

118 mL kit

Storage & Organization

Resin Storage Bottles (Dark)

UV-blocking amber HDPE bottles for storing partially used resin cartridges. Prevents premature curing during storage.

Pack of 6 × 1 L

Filament Dry Box

Sealed storage box with desiccant for keeping hygroscopic filaments (nylon, PEEK, TPU) dry between print runs.

Single unit

Building out your post-processing station?

Contact us for bundle pricing on safety equipment, finishing supplies, and storage solutions.

Request a Quote